So I recently purchased my first Zemismart Roller Shader Driver to replace an older Ikea blind system which had up and died on me. I’ve detected it no issues on my Samsung SmartThings V3 hub but it detected it as a “Zigbee Thing” and all the community based drivers I’ve found don’t seem to work correctly
They work as in I can open and close the blinds but they lose the pre-set limits and have no way to set the limits themselves - I have tried following the instructions and setting the limits before adding it to the hub as well as setting it after adding it to the hub as well - no change.
I can’t seem to find ANY official Zemismart presence on the SmartThings community pages and since they changed everything to the new system you can’t just add someone else’s drivers like you use to so even though Zemismart has some SmartThings drivers hosted on their website which might work I can’t really just upload them and try them that way as the new system is meant to be that the driver owner uploads them and then people subscribe to their drivers.
Is Zemismart going to be putting up an official channel of their drivers any time soon? Obviously the switch works manually - and luckily all three bulbs on the other end of the three switches are also smart devices so I can still control them that way too - but I would really like to be able to configure the labels and control it all remotely too please ![]()
Confirmation of it’s details:
Model ZMP1
SmartThings sees it as:
TS601